Yamaha STAR XVS95CE 2DX1 2014 Service Manual page 91

1. Fuel tank breather/overflow hose (fuel tank to hose
joint)
2. Fuel tank breather/overflow hose (hose joint to
rollover valve)
3. Hose joint
4. Fuel filter
5. Fuel hose (fuel pump to fuel filter)
6. Fuel pump
7. Fuel hose (hose joint to pressure regulator)
8. Fuel sender lead
9. Fuel sender
10. Frame
11. Fuel hose (hose joint to fuel tank)
A. Install the fuel tank breather/overflow hose (fuel
tank to hose joint) completely onto the hose fitting.
B. Install the fuel tank breather/overflow hose (fuel
tank to hose joint) with its white paint mark facing
rearward.
C. Align the hose clamp with the white paint mark on
the fuel tank breather/overflow hose (fuel tank to
hose joint) and point the ends of the clamp
rearward.
D. 18 mm (0.71 in) or more
E. 8 mm (0.31 in) or more
F. Make sure not to install the hose clamps on the
raised portions of the hose fittings.
G. Connect the orange connector of the fuel hose
(fuel pump to fuel filter) to the fuel pump.
H. 0 mm (0 in) or more
I. Install the fuel hose (hose joint to pressure
regulator) completely onto the hose fitting of the
pressure regulator, making sure that the yellow
paint mark on the hose is facing outward.
J. Align the ends of the hose clamp with the yellow
paint mark on the fuel hose (hose joint to pressure
regulator). Make sure not to install the hose clamp
on the raised portion of the hose fitting.
K. Install the fuel sender so that the fuel sender lead
is routed inward.
L. Make sure that the end of the hose clamp contacts
the frame.
M. Install the fuel hose (hose joint to pressure
regulator) completely onto the hose joint, making
sure that the white paint mark on the hose is
positioned on the same side of the hose joint as
the arrow mark.
N. Arrow mark
O. Align the hose clamp with the edge of the white
paint mark on the fuel hose (hose joint to fuel
tank), making sure to align the crimped section of
the clamp with the paint mark.
P. Install the fuel hose (hose joint to fuel tank)
completely onto the hose fitting, making sure that
the white paint mark on the hose is facing
downward.
Q. Fasten the fuel hose (hose joint to pressure
regulator) with the holder.
R. Route the fuel sender lead through the guide, and
then secure the lead by bending the guide around
the lead.
2-64
CABLE ROUTING