Yamaha STAR XVS95CE 2DX1 2014 Service Manual page 267

2. Install:
• Clutch housing "1"
TIP
• Fit the projections "a" on the oil pump drive
sprocket into the grooves "b" in the clutch
housing.
• Lubricate the clutch housing bearing with en-
gine oil.
• Make sure that the primary driven gear teeth
and primary drive gear teeth mesh correctly.
• After installing the clutch housing, make sure
that the primary drive gear "2" and clutch hous-
ing primary driven gear "3" are aligned as
shown in the illustration.
3
3. Install:
• Clutch boss "1"
• Washer
• Conical spring washer "2"
• Clutch boss nut "3"
Clutch boss nut
125 Nm (12.5 m·kgf, 90 ft·lbf)
2
New
TIP
• Lubricate the clutch boss nut threads and con-
ical spring washer mating surfaces with engine
oil.
• Install the conical spring washer with the
"OUT" mark "a" facing out.
• While holding the clutch boss with the univer-
sal clutch holder "4", tighten the clutch boss
nut.
• Stake the clutch boss nut "3" at cutout "b" in the
main axle.
Universal clutch holder
90890-04086
YM-91042
4. Lubricate:
• Friction plates
• Clutch plates
(with the recommended lubricant)
Recommended lubricant
Engine oil
5. Install:
• Friction plates 2
• Clutch plates
• Friction plates 1
TIP
• First, install a friction plate and then alternate
between a clutch plate and a friction plate.
• Align the cutout in the tab of each friction plate
1 and 2 with the "
housing and align the cutout in the tab of the
last friction plate 1 "1" with the punch mark "b"
on the housing.
5-56
CLUTCH
" mark "a" on the clutch