Yamaha STAR XVS95CE 2DX1 2014 Service Manual page 81

1. Right handlebar switch lead
2. Left handlebar switch lead
3. Main switch lead
4. Fuel pump lead
5. Main switch coupler (white)
6. Main switch coupler (red)
7. Rear cylinder injector lead
8. Front cylinder injector coupler
9. ISC (idle speed control) unit coupler
10. Engine temperature sensor coupler
11. Right handlebar switch coupler
12. Front brake hose
A. Route the right handlebar switch lead through the
cable guide.
B. Route the left handlebar switch lead to the outside
of the cable guide.
C. Insert the projection on the left handlebar switch
lead holder into the hole in the cable guide.
D. Route the fuel pump lead to the outside of the
main switch leads, and then fasten the fuel pump
lead with the holder.
E. Fasten the main switch leads with the plastic band.
Be sure to fasten the plastic band around the
protective sleeves of the leads, not the leads
themselves.
F. Fasten the main switch couplers with the plastic
band. Be sure to position the main switch coupler
(red) above the main switch coupler (white).
G. Connect the rear cylinder injector coupler, which
has white tape on the lead, to rear cylinder injector.
H. After connecting the engine temperature sensor
coupler, cover the coupler with the coupler cover.
I. To the fuel pump
J. Route the right handlebar switch lead under the
engine bracket (front upper side).
K. Install the right handlebar switch coupler (4-pin)
onto the tab on the engine bracket (front upper
side) and insert the projection on the right
handlebar switch coupler (8-pin) into the hole in the
bracket.
L. Route the main switch lead between the right
handlebar switch leads and the engine bracket
(front upper side).
M. Insert the projection on the right handlebar switch
lead holder into the hole in the cable guide.
N. Route the right handlebar switch lead to the inside
of the front brake hose.
2-54
CABLE ROUTING