Yamaha STAR XVS95CE 2DX1 2014 Service Manual page 73

1. Lean angle sensor
2. Tail sub-wire harness
3. Wire harness
4. Clutch cable
5. Starter motor lead
6. Rear brake light switch
7. O sensor
2
8. Brake fluid reservoir hose
9. Positive battery lead
10. Frame
11. Rear brake light switch lead
A. Insert the projection on the tail sub-wire harness
holder into the hole in the battery box.
B. Secure the holder by inserting the projection on
the holder into the hole in the battery box bracket,
and then fasten the clutch cable and wire harness
with the holder.
C. Insert the projection on the starter motor lead
holder into the hole in the engine bracket (front
lower side).
D. Insert the projection on the starter motor lead
holder into the hole in the engine bracket (rear
lower side).
E. Fasten the brake fluid reservoir hose, rear brake
light switch lead, and O
2
plastic band. Face the buckle of the plastic band
upward with the end pointing downward.
F. Insert the projection on the wire harness holder
into the hole in the battery box.
G. Insert the projection on the positive battery lead
holder into the hole in the battery box.
H. Face the catch of the holder forward. Route the
clutch cable to the outside of the wire harness.
I. Route the rear brake light switch lead and starter
motor lead through the guide, and then secure the
leads by bending the guide around the leads.
Route the rear brake light switch lead to the
outside of the starter motor lead. Make sure that
the leads do not protrude.
sensor lead with the
2-46
CABLE ROUTING