Installing The Shift Arm; Adjusting The Shift Pedal - Yamaha XVS950CU 2014 Service Manual

EAS1TP1050

INSTALLING THE SHIFT ARM

1. Install:
• Shift arm "1"
Shift arm bolt
16 Nm (1.6 m·kgf, 12 ft·lbf)
TIP
Align the "I" mark "a" in the shift shaft with the
punch mark "b" in the shift arm.
1
EAS21380

ADJUSTING THE SHIFT PEDAL

TIP
The shift pedal position is determined by the in-
stalled shift rod length.
1. Measure:
• Installed shift rod length "a"
Incorrect → Adjust.
Installed shift rod length
93.7–97.7 mm (3.69–3.85 in)
2. Adjust:
• Installed shift rod length
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Loosen both locknuts "1".
ECA1TP1026
NOTICE
The shift rod locknut (shift pedal side) has
left-hand threads.
b. Turn the shift rod "2" in direction "a" or "b" to
obtain the correct shift rod length.
a
b
a
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
TIP
Make sure that the engaged thread length on
both ends of the shift rod is 4 ridges or more.
Direction "a"
Installed shift rod length is increased.
Direction "b"
Installed shift rod length is decreased.
c. Tighten the locknuts to specification.
d. Make sure the installed shift rod length is
within specification.
▲ ▲▲▲ ▲ ▲▲▲ ▲
▼▼▼
5-9
ENGINE REMOVAL
1
a
b
2
Locknut
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲