1. Intake air pressure sensor hose
2. Hose fitting
3. Canister purge hose (for California)
A. Point the ends of the hose clamp to the right.
B. Install the intake air pressure sensor hose
completely onto the hose fitting, making sure that
the yellow paint mark on the hose is facing upward.
–
–
C. 1
2 mm (0.04
0.08 in)
D. Install the canister purge hose completely onto the
hose fitting, making sure that the blue paint mark
on the hose is facing upward. (for California)
–
–
E. 2
4 mm (0.08
0.16 in)
F. Align the hose clamp with the blue paint mark on
the canister purge hose and point the ends of the
clamp forward.
2-72
CABLE ROUTING