Pppoe Intermediate Agent - Edge-Core ECS4620-28T Quick Start Manual

PPPoE Intermediate Agent

telnet-client - Displays IP addresses for the Telnet group.
Command Mode
Privileged Exec
Example
Console#show management all-client
Management Ip Filter
HTTP-Client:
Start IP address
-----------------------------------------------
1. 192.168.1.19
2. 192.168.1.25
SNMP-Client:
Start IP address
-----------------------------------------------
1. 192.168.1.19
2. 192.168.1.25
TELNET-Client:
Start IP address
-----------------------------------------------
1. 192.168.1.19
2. 192.168.1.25
Console#
This section describes commands used to configure the PPPoE Intermediate Agent
(PPPoE IA) relay parameters required for passing authentication messages between
a client and broadband remote access servers.
Table 50: PPPoE Intermediate Agent Commands
Command
pppoe intermediate-agent
pppoe intermediate-agent
format-type
pppoe intermediate-agent
port-enable
pppoe intermediate-agent
port-format-type
pppoe intermediate-agent
port-format-type remote-
id-delimiter
pppoe intermediate-agent
trust
pppoe intermediate-agent
vendor-tag strip
Chapter 8
End IP address
192.168.1.19
192.168.1.30
End IP address
192.168.1.19
192.168.1.30
End IP address
192.168.1.19
192.168.1.30
Function
Enables the PPPoE IA globally on the switch
Sets the access node identifier and generic error message
for the switch
Enables the PPPoE IA on an interface
Sets the circuit-id or remote-id for an interface
Sets the remote-id delimiter for an interface
Sets the trust mode for an interface
Enables the stripping of vendor tags from PPPoE Discovery
packets sent from a PPPoE server
– 293 –
| Authentication Commands
PPPoE Intermediate Agent
Mode
GC
GC
IC
IC
IC
IC
IC