Radius-Server Timeout - Dell PowerConnect 7000 Series Reference Manual

no radius-server source-ip
source — Specifies the source IP address.
•
Default Configuration
The default IP address is the outgoing IP interface.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the source IP address used for
communication with Radius servers to 10.1.1.1.
console(config)#radius-server source-ip 10.1.1.1

radius-server timeout

Use the radius-server timeout command in Global Configuration mode to set
the interval for which a switch waits for a server host to reply. To restore the
default, use the no form of this command.
Syntax
radius-server timeout
no radius-server timeout
timeout — Specifies the timeout value in seconds. (Range: 1–30)
•
Default Configuration
The default value is 3 seconds.
Command Mode
Global Configuration mode
716
RADIUS Commands
timeout