Show Ipv6 Pim Rp Mapping - Dell PowerConnect 7000 Series Reference Manual

If no RP Group mapping exist on the router, the following message is
displayed:
No RP-Group mappings exist/learnt on this router.

show ipv6 pim rp mapping

Use the show ipv6 pim rp mapping command to display the mappings for the
PIM group to the active Rendezvous Points (RPs).
Syntax
show ipv6 pim rp mapping [
Parameter Description
Parameter
rp-address
Default Configuration
There is no default configuration for this command.
Command Mode
User EXEC, Privileged EXEC modes
User Guidelines
There are no user guidelines for this command. Field descriptions are shown
in the following table.
Field
RP Address
Group Address
Origin
Example
(console) # show ipv6 pim rp mapping candidate
rp-address
Description
IP address of the RP
Description
Address of the RP
Address of the multicast group
Origin from where this group mapping is learned
]
IPv6 PIM Commands
1007