Radius-Server Deadtime - Dell PowerConnect 7000 Series Reference Manual

Example
The following example specifies a priority of 10 for the designated server.
console(config)#radius-server host 192.143.120.123
console(config-radius)#priority 10

radius-server deadtime

Use the radius-server deadtime command in Global Configuration mode to
configure the minimum amount of time to wait before attempting to
recontact an unresponsive RADIUS server. If a RADIUS server is currently
active and responsive, that server will be used until it no longer responds.
RADIUS servers whose deadtime interval has not expired are skipped when
searching for a new RADIUS server to contact. To set the deadtime to 0, use
the no form of this command.
Syntax
radius-server deadtime
no radius-server deadtime
deadtime — Length of time in minutes, for which a Radius server is
•
skipped over by transaction requests. (Range: 0–2000 minutes). Deadtime
is used to mark an unavailable Radius server as dead until this user-
configured time expires. Deadtime is configurable on a Radius server basis.
Default Configuration
The default dead time is 0 minutes.
Command Mode
Global Configuration mode
User Guidelines
If only one RADIUS server is configured, it is recommended that the
deadtime interval be left at 0.
712
RADIUS Commands
deadtime