Ip Pim Register-Rate-Limit - Dell PowerConnect 7000 Series Reference Manual

ip pim register-rate-limit

Use the ip pim register-rate-limit command in Global Configuration mode
to set a limit on the maximum number of PIM register messages sent per
second for each (S,G) entry. Use the no form of this command to return the
limit to its default value (0). This command replaces the ip pimsm spt-
threshold command.
Syntax
ip pim register-rate-limit
no ip pim register-rate-limit
Parameter Description
Parameter
register-rate-limit
Default Configuration
The default threshold is 0. This indicates that the register limit is infinite.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
console(config)#ip pim register-rate-limit 10
ip pim rp-address
Use the ip pim rp-address command in Global Configuration mode to define
the address of a PIM Rendezvous point (RP) for a specific multicast group
range. Use the no form of this command to remove a configured RP. This
command replaces the ip pimsm rp-address command.
1078
Multicast Commands
0-2000
Description
The PIM register message limit in kilobytes per second. Range
0-2000.