Iscsi Enable - Dell PowerConnect 7000 Series Reference Manual

Example
The following example configures iSCSI packets to receive CoS treatment
using DiffServ Code Point AF 41 and configures remarking of transmitted
iSCSI packets.
console(config)#iscsi cos dscp 10 remark

iscsi enable

The iscsi enable command globally enables iSCSI optimization. To disable
iSCSI optimization, use the no form of this command.
Syntax
iscsi enable
no iscsi enable
Default Configuration
iSCSI is enabled by default.
Command Mode
Global Configuration mode
User Guidelines
This command modifies the running config to enable flow control on all
interfaces.
Monitoring for EqualLogic Storage arrays via LLDP is also enabled by this
command. Upon detection of an EQL array, the specific interface involved
will have spanning-tree portfast enabled and unicast storm control disabled.
These changes appear in the running config. Disabling iSCSI Optimization
does not disable flow control, portfast or storm control configuration applied
as a result of enabling iSCSI Optimization.
Enabling iSCSI will enable the sending of the DCBX Application Priority
TLV to a port with the following parameters when the following conditions
are met:
• DCBX is enabled
• CoS Queuing is enabled on the port using VPT
iSCSI Optimization Commands
563