Ip Name-Server - Dell PowerConnect 7000 Series Reference Manual

User Guidelines
This command has no user guidelines.
Example
The following example defines a static host name-to-address mapping in the
host cache.
console(config)#ip host accounting.dell.com
176.10.23.1

ip name-server

Use the ip name-server command in Global Configuration mode to define
available IPv4 or IPv6 name servers. To delete a name server, use the no form
of this command.
Syntax
ip name-server
no ip name-server [
server-address — Valid IPv4 or IPv6 addresses of the name server. (Range:
•
1–255 characters)
Default Configuration
No name server IP addresses are specified.
Command Mode
Global Configuration mode
User Guidelines
Server preference is determined by entry order.
Up to eight servers can be defined in one command or by using multiple
commands. Use the show hosts command on page 517 to display the
configured name servers.
510
IP Addressing Commands
server-address1
[
server-address1 ... server-address8
server-address2 ... server-address8
]
]