Ip Helper-Address (Interface Configuration) - Dell PowerConnect 7000 Series Reference Manual

ip helper-address (interface configuration)

Use the ip helper-address (interface configuration) command to configure
the relay of certain UDP broadcast packets received on a specific interface. To
delete a relay entry on an interface, use the no form of this command.
Syntax
ip helper-address { server-address | discard } [ dest-udp-port | dhcp |
domain | isakmp | mobile ip | nameserver | netbios-dgm | netbios-ns | ntp
| pim-auto-rp | rip | tacacs | tftp | time ]
no ip helper-address [
domain | isakmp | mobile-ip | nameserver | netbios-dgm | netbios-ns | ntp
| pim-auto-rp | rip | tacacs | tftp | time ]
server-address — The IPv4 unicast or directed broadcast address to which
•
relayed UDP broadcast packets are sent. The server address cannot be an
IP address configured on any interface of the local router.
• discard — Matching packets should be discarded rather than relayed, even
if a global ip helper-address configuration matches the packet.
dest-udp-port — A destination UDP port number from 0 to 65535.
•
port-name — The destination UDP port may be optionally specified by its
•
name. Whether a port is specified by its number or its name has no effect
on behavior. The names recognized are as follows: dhcp (port 67), domain
(port 53), isakmp (port 500), mobile-ip (port 434), nameserver (port 42),
netbios-dgm (port 138), netbios-ns (port 137), ntp (port 123), pim-auto-
rp (port 496), rip (port 520), tacacs (port 49), tftp (port 69), and time
(port 37). Other ports must be specified by number.
Default Configuration
No helper addresses are configured.
Command Mode
Interface Configuration (VLAN) mode.
server-address
| discard ] [
IP Helper/DHCP Relay Commands
dest-udp-port
| dhcp |
957