Ip Mcast Boundary - Dell PowerConnect 7000 Series Reference Manual

ip mcast boundary

Use the ip mcast boundary command in Interface Configuration mode to
add an administrative scope multicast boundary specified by
mask
for which this multicast administrative boundary is applicable.
groupipaddr
is a group IP address and
Syntax
ip mcast boundary
no ip mcast boundary
groupipaddr — IP address of multicast group. Valid range is 239.0.0.0 to
•
239.255.255.255.
mask — IP mask of multicast group.
•
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example adds an administrative scope multicast boundary.
console(config)#interface vlan 15
console(config-if-vlan15)#ip mcast boundary 239.5.5.5
255.255.255.255
ip mroute
Use the ip mroute command to create a static multicast route for a source
range. Use the no form of this command to delete a static multicast route.
groupipaddr mask
groupipaddr mask
mask
is a group IP mask.
Multicast Commands
groupipaddr
and
1069