Setting The Vertical Baseline - QuickLabel QL-800 User Manual

QL-800 Maintenance Utility

Setting the Vertical Baseline

If you send the same job to two or more QL-800 printers and notice that the image prints in
different locations, you can move the vertical baseline of a printer.
Note: Adjusting the baseline is needed only for synchronizing the output of two or more
printers. Baselines are adjusted at the factory and should be close from printer to printer. If you
are using one QL-800, baseline adjustment is not necessary.
1
2
3
4
5
68
Launch the QL-800 Maintenance Utility.
From the Windows Start Menu, choose
QL-800 Maintenance Utility. A language and printer prompt will open.
Select a display language and the QL-800 printer you want to connect to. Choose OK.
Choose the Print Settings
To read the vertical baseline value from the printer and set the
accordingly, choose Read From
Enter a vertical baseline value.
In the following illustration, a label is exiting the printer. Note the positive and negative
adjustment directions.
To save the vertical baseline value, choose
Start > All Programs > QuickLabel QL-800 >
tab.
Printer.
Save to
Vertical Baseline
Printer.
QL-800 User Guide
control