Table of Contents
Advertisement
8
9
10
Installing the Rewinder when using the External Unwinder
Use the following instructions to install the rewinder when also using the external unwinder.
Refer to the following illustration during this process.
Note: These instructions assume you are using the rewinder accessory and the external
unwinder accessory. If you are using only the rewinder accessory, the installation procedure
will differ.
1
2
3
QL-800 User Guide
Install the two thumb screws through the bracket [4] slots and into the rewinder [5].
Note: Do not fully tighten the thumb screws at this time. You will tighten the thumb screws
after ensuring proper alignment in the rewinding procedure.
Plug the power jack into the power slot on the rewinder. Insert the power plug into an AC
power receptacle.
On the rear of the printer, turn the power inlet switch on. Power on the printer.
[1]
[2]
See "Installing the Rewinder" on page 136.
Before installing the rewinder, ensure the external unwinder is installed properly.
"Installing the External Unwinder" on page 142.
Store the rewinder bracket in case it is needed in the future.
The bracket supplied with the rewinder is not needed during this procedure. Instead, the
rewinder will be attached to the front end of the unwinder bracket.
Note: Do not discard the rewinder bracket. It is required for installing the rewinder when
not using the external unwinder.
Ensure the power switch [1] on the rewinder is in the off position.
[3]
Rewinder
See
137
Advertisement
Table of Contents
