Table of Contents
Advertisement
10
Before shipping this printer, please read this section thoroughly. These shipping precautions
must be followed to reduce the risk of printer damage during shipping.
Please contact Technical Support if you have any questions or concerns about shipping your
printer.
Caution: Do not ship a printer without following the shipping precautions. Failure to follow the
precautions may result in catastrophic printer damage that will not be covered by any warranty.
Use the Before Shipping Feature
Use the
"Preparing for Shipping" on page 73.
The maintenance wizard will guide you through the following actions:
•
•
•
•
Caution: If you are unable to use the Before Shipping function due to an error condition, leave
the ink cartridges installed in the printer. This will help prevent ink leakage if there is a problem.
Pack the Printer Carefully
Observe the following guidelines when packing the printer for shipping.
•
•
•
•
QL-800 User Guide
Before Shipping
feature in the
Draining ink from the printhead
Removing the printhead
Removing ink cartridges
Securing the maintenance roller
Install the original protective caps on the two fluidic couplings in the printhead area.
Install the four absorbent pads in the ink cartridge slots.
Pack the printer in the original packaging material and shipping carton. The printer should
be shipped in its original packaging and strapped to the shipping pallet.
If you are sending the printer to QuickLabel for factory service, please do not ship the
printhead or ink cartridges. Store the printhead in its original plastic tray and packaging
material.
Shipping Precautions
Cleaning
tab of the QL-800 Maintenance Utility.
See
147
Advertisement
Table of Contents
