Table of Contents
Advertisement
9
Before Installing the External Unwinder
Before installing the unwinder, observe the following precautions.
•
•
•
•
•
•
QL-800 User Guide
No unwinder feet should float. The unwinder must be held level constantly.
The unwinder must be installed on the same plane as the printer.
The unwinder weighs 25 pounds (11.3 kilograms). When placing the unwinder on a desk,
table, or other similar surface, it must be sturdy and stable enough to support the weight of
the printer, unwinder, and roll media. A table that can support at least 150 pounds (68
kilograms) is recommended.
The unwinder and associated bracket require a surface 43 inches (1093 mm) in length and
21 inches (534) in width.
If you are installing both the rewinder and unwinder, a surface 51 inches (1296 mm) in
length and 21 inches (534 mm) in width is required.
Do not turn the unwinder mandrel by hand to unwind the media. Turning the mandrel by
hand can result in unwinder damage.
External Unwinder
141
Advertisement
Table of Contents
