Setting The Cut/Stop Position; Setting Up External Unwind Mode - QuickLabel QL-800 User Manual

QL-800 Maintenance Utility

Setting the Cut/Stop Position

The cut/stop position setting adjusts the position at which media is fed after printing. You can
adjust the cut/stop position -20 to +20 mm.
1
2
3
4
5

Setting up External Unwind Mode

External unwind mode is used when an external unwinder accessory is supplying media to the
printer.
1
2
3
4
5
70
Launch the QL-800 Maintenance Utility.
From the Windows Start Menu, choose
QL-800 Maintenance Utility. A language and printer prompt will open.
Select a display language and the QL-800 printer you want to connect to. Choose OK.
Choose the Print Settings
To read the cut/stop position value from the printer and set the
accordingly, choose Read From
Enter a cut/stop position value.
• Positive values result in more media being fed after printing before the media stops.
• Negative values result in less media being fed after printing before the media stops.
To save the cut/stop position values, choose
See "External Unwinder" on page 141.
Launch the QL-800 Maintenance Utility.
From the Windows Start Menu, choose
QL-800 Maintenance Utility. A language and printer prompt will open.
Select a display language and the QL-800 printer you want to connect to. Choose OK.
Choose the Print Settings
To read the external unwind mode setting from the printer and set the
Mode control accordingly, choose
Select an External Unwind Mode
• Disabled - Choose this option if you will supply media to the printer with the printer's
mandrel.
• Enabled - Choose this option if you will supply media to the printer with an external
unwinder.
To save the setting, choose
Start > All Programs > QuickLabel QL-800 >
tab.
Printer.
Save to
Start > All Programs > QuickLabel QL-800 >
tab.
Read From Printer.
setting.
Save to Printer.
Cut/Stop Position
Printer.
External Unwind
QL-800 User Guide
control