Table of Contents
Advertisement
External Unwinder
Installing the External Unwinder
Use the following instructions to install the unwinder. Refer to the following illustration during
this process.
1
2
3
4
5
6
142
Use the
Before Moving
utility will prepare the printer for lifting and moving onto the brackets.
Moving" on page 73.
Power off the printer. On the rear of the printer, turn the power inlet switch off.
Ensure the power switch on the unwinder [2] is in the off position.
Arrange the brackets [1] as illustrated. Insert the tabs into the corresponding slots on the
brackets.
Align the unwinder [2] with the bracket. Ensure the thumb screw mounting locations align
with the slotted holes on the bracket.
Install the two thumb screws [3] through the bracket slots and into the unwinder [2].
Note: Do not fully tighten the thumb screws at this time. You will tighten the thumb screws
after ensuring proper alignment.
[1]
feature in the
Cleaning
tab of the QL-800 Maintenance Utility. This
[3]
See "Preparing for
QL-800 User Guide
[2]
Advertisement
Table of Contents
