Designing and Printing Labels
4
5
6
Using Service Options
You can clean the printheads, launch the status monitor, order supplies, and contact technical
support using the printer driver.
1
52
Select a sensor type.
•
Gap
- Choose this option if you are using gap media.
•
Reflective
- Choose this option if you are using reflective mark media.
•
None
- Choose this option if you are using media without gaps or reflective marks
(continuous media).
•
Hole or Notch
- Choose this option if you are using media with die-cut holes or
notches.
Select the cutter settings.
•
Check the
Cut at End of Job
•
Use the
Labels Between Cut
each cut.
Choose OK.
Open the appropriate printer window based on your version of Windows.
•
In Windows 7, choose
•
In Windows 8 and 10, access the Search option by pointing to the upper-right corner of
the screen. Search for "Control Panel" and click the
Panel window, click
Right-click the printer icon and choose
Preferences window will open.
Note: You can also access the driver preferences via the application's print dialog. From
the Print window in your software, select QuickLabel QL-800 from the printer list and
choose Properties or Setup (varies based on program).
option to enable the auto-cutter.
field to indicate the number of labels to print between
Start > Devices and
View Devices and
Printers.
Printing
Printers.
Control Panel
icon. In the Control
Preferences. The QL-800 Driver Printing
QL-800 User Guide