Error 1018 - Reserved
This error is reserved (not applicable).
Error 1019 - Reserved
This error is reserved (not applicable).
Error 101A - TOF Calibration
The printer is not ready to start calibration.
Solutions
Use the following solutions to troubleshoot the issue. The most likely solutions are listed first,
followed by other possibilities. Check to see if the issue is resolved after performing each
recommended solution. If the issue is not resolved, proceed to the next solution. If the issue
persists after performing all solutions, contact Technical Support.
1) Press and hold the pause/resume key to cancel the job.
Error 1020 - Shared Memory Read Timeout
There is an internal communications failure.
Solutions
Use the following solutions to troubleshoot the issue. The most likely solutions are listed first,
followed by other possibilities. Check to see if the issue is resolved after performing each
recommended solution. If the issue is not resolved, proceed to the next solution. If the issue
persists after performing all solutions, contact Technical Support.
1) Press and release the power key to clear the error.
2) Press and hold the power key on the operation panel for three seconds to turn the printer
3) On the rear of the printer, turn the power inlet switch off. Wait three seconds. Then turn the
QL-800 User Guide
Press and release the power key to clear the error.
off. Wait three seconds. Then press and hold the power key for one second to turn the
printer on again.
power inlet switch on. Power on the printer.
Error Messages
101