Table of Contents
Advertisement
Getting Started
Working with Wide Gap Media
Gap media with wide gaps between labels may require special handling. If the gaps are larger
than 0.125 inches (3.175 mm), observe the following guidelines.
•
•
Working with Reflective Mark Media
Reflective mark media may require special handling to ensure proper top-of-form calibration.
Observe the following guidelines when using reflective mark media.
•
•
•
QuickLabel Services
QL-800 Label Materials
QuickLabel develops QL-800 label printing substrates. We sell cost-effective labels that meet
various end-use requirements, including industry and government regulatory labeling
standards.
QuickLabel BPO Blanket Purchase Order Program
As the manufacturer of the QL-800 and the supplies, QuickLabel has the advantage of
providing you with lower prices due to production efficiencies. QuickLabel's QL-800 BPO
Program covers all of your requirements for printing supplies over a 12-month period. You
receive a discounted price for your annual commitment and regular scheduled deliveries based
on your production requirements. Customers who take advantage of our BPO program receive
maximum savings on all of their ink and blank label purchases!
36
Before loading media, trim excess liner from the leading edge of the media roll. If the
leading edge has more than 0.125 inches (3.175 mm) of exposed liner material, it may be
difficult to load media properly.
Adjust the cut/stop position so a leading edge of 0.125 inches (3.175 mm) or less of
exposed liner material results after each print job.
page 70.
Ensure the reflective mark meets the width, length, and density requirements.
Specifications" on page 156.
Before loading media, ensure that the leading edge of the media contains no reflective
mark within the first ¼ inch from the cut edge. If any part of the reflective mark is within this
area, cut the media directly behind the mark removing the entire mark but as little of the
unmarked liner as possible. Then the media can be loaded into the printer without concern
for a poor top-of-form calibration.
If necessary, adjust the vertical offset in the printer driver. Also make sure the reflective
sensor type is selected.
See "Setting up Media Options" on page 50.
See "Setting the Cut/Stop Position" on
QL-800 User Guide
See "Label
Advertisement
Table of Contents
