Table of Contents
Advertisement
3
Preparing the Maintenance Roller
A foam block is installed over the maintenance roller to protect it during shipping. Use the
following instructions to remove this foam block.
1
2
3
QL-800 User Guide
Choose
After
Shipping. Follow the on-screen instructions to complete this procedure. This
wizard will guide you through the following actions.
•
Preparing the Maintenance Roller -
27.
•
Installing Ink Cartridges -
•
Installing the Printhead -
Open the top cover and remove the cinch strap [1].
Remove the foam support block [2] from the printer. Use caution when removing the block
to avoid dislodging the maintenance roller assembly.
Save the foam support block and strap for future shipping purposes.
Verify that the maintenance roller assembly is level and installed properly. Make sure both
ends of the roller are snapped into place.
See "Preparing the Maintenance Roller" on page
See "Installing Ink Cartridges" on page 28.
See "Installing the Printhead" on page 29.
[1]
Getting Started
[2]
27
Advertisement
Table of Contents
