Identifying Snmp Trap Messages - Oracle X7-2 Service Manual

Identifying SNMP Trap Messages

Component Name (Oracle ILOM CLI
Targets)
/SYS/DBP/HDD[0-x]/SERVICE
/SYS/DBP/HDD[0-x]/OK2RM
/SYS/DBP/HDD[0-x]/NVME
/SYS/DBP/HDD[0-x]/NVME/PRSNT
Related Information
"System Chassis Components" on page 285
■
"Cooling Unit Components" on page 287
■
"Disk Backplane Components" on page 287
■
"Memory Device Components" on page 289
■
"Power Unit Components" on page 289
■
"Processor Components" on page 290
■
"System Motherboard Components" on page 291
■
"System Firmware Components" on page 293
■
Identifying SNMP Trap Messages
It is possible to configure Oracle ILOM to generate Simple Network Management Protocol
(SNMP) traps when hardware problems occur. For information about how to configure SNMP
alert rule destinations to start receiving these traps, refer to the Oracle Integrated Lights Out
Manager (ILOM) 4.0 Documentation Library at:
http://www.oracle.com/goto/ilom/docs
294 Oracle Server X7-2 Service Manual • October 2017
IPMI Type Description
Indicator Hard disk drive Fault-Service
Required LED
Indicator Hard disk drive OK to Remove LED
FRU NVMe drive FRU
Discrete sensor NVMe device presence
Values (if applicable)
20h-SLOT_POWER_OFF
Color: Amber
Location: HDD
Off: Normal
On: Hard disk drive was diagnosed
as faulty.
Color: Blue
Location: HDD
Off: Normal
On: Drive is ready to remove
01h-ENTITY_ABSENT
02h-ENTITY_PRESENT