Oracle X7-2 Service Manual page 194

Remove the Power, FIM, Temperature Sensor, and Disk Backplane Data Cables
Remove the Power, FIM, Temperature Sensor, and Disk
Backplane Data Cables
1. Prepare the server for service.
a. Power off the server and disconnect the power cords from the power
supplies.
See
b. Extend the server to the maintenance position.
See
Attach an antistatic wrist strap to your wrist, and then to a metal area on the
c.
chassis.
See
d. Remove the server top cover.
See
Remove the disk backplane power cable.
2.
a. Disconnect the disk backplane power cable from the motherboard by
pressing the release latch on the side of the cable connector and pulling out
the connector [1].
194 Oracle Server X7-2 Service Manual • October 2017
"Powering Down the Server" on page
"Extend the Server to the Maintenance Position" on page
"Take Antistatic Measures" on page
"Remove the Server Top Cover" on page
53.
59.
61.
62.