Oracle Server X7-2 Service Manual • October - Oracle X7-2 Service Manual

Remove the Disk Backplane
a. Power off the server and disconnect the power cords from the power
supplies.
See
b. Extend the server to the maintenance position.
See
c. Attach an antistatic wrist strap to your wrist, and then to a metal area on the
chassis.
See
Remove the server top cover.
d.
See
e. Lift up the super capacitor to release the capacitor from the reclosable
fasteners that secure it to the chassis.
Set the super capacitor aside (leaving the super capacitor cable attached) until you are
ready to install the replacement storage drive backplane.
2. Pull all storage drives out far enough to disengage them from the disk
backplane.
See "Remove a Storage Drive" on page
Note -
pull them out far enough to disengage them from the disk backplane. If you do remove the
storage drives from the server, record their locations so that you can reinstall them in the same
locations.
152 Oracle Server X7-2 Service Manual • October 2017
"Powering Down the Server" on page
"Extend the Server to the Maintenance Position" on page
"Take Antistatic Measures" on page
"Remove the Server Top Cover" on page
It is not necessary to completely remove the storage drives from the server; simply
53.
61.
62.
67.
59.