Verify Operation Of An Nvme Storage Drive; Server; Remove An Nvme Storage Drive - Oracle X7-2 Service Manual

Verify Operation of an NVMe Storage Drive

Verify Operation of an NVMe Storage Drive
To verify that an NVMe drive is operating properly, do one of the following:
Check the /var/log/messages log file.
■
Type: #
■
Related Information
"Storage Drive Status Indicators" on page 31
■
"Storage Drives Hot-Plug Conditions" on page 65
■
"Storage Drive Failure and RAID" on page 66
■
"Storage Drive Locations and Numbering" on page 66
■
Removing and Replacing an NVMe Storage Drive Using
Microsoft Windows Server
The following sections describe how to remove and replace an NVMe storage drive on a server
that is running the Microsoft Windows Server operating system.
Note -
Microsoft Windows Server. The system must be powered down before removing and replacing
an NVMe storage drive.
"Remove an NVMe Storage Drive" on page 78
■
"Install an NVMe Storage Drive" on page 79
■

Remove an NVMe Storage Drive

Perform this procedure to physically remove an NVMe storage drive from the server.
1. Power down the server that contains the storage drive to be removed.
See "Powering Down the Server" on page
2. On the NVMe drive you plan to remove, push the latch release button to open the
drive latch.
78 Oracle Server X7-2 Service Manual • October 2017
ls -l /dev/nvme*
NVMe storage drive hot plug is not supported for an Oracle Server X7-2 running
53.