Servicing System Module (Smod) Components (Fru); Smod Population Rules; Remove An Smod - Oracle X7-8 Service Manual

Servicing System Module (SMOD) Components (FRU)

This section contains removal and installation procedures for the SMOD:
"SMOD Population Rules" on page 195
■
"Remove an SMOD" on page 195
■
"Install an SMOD" on page 197
■
"Servicing the Host Bus Adapter (HBA) Card" on page 200
■
"Servicing the Energy Storage Module and Cables" on page 206
■
"Servicing the Internal USB Flash Drives" on page 213
■
"Replace the System Battery" on page 216
■
Caution -
personnel.
See "System Module (SMOD) Overview" on page

SMOD Population Rules

The Oracle Server X7-8 supports two installed SMODs. Both SMOD0 System A and SMOD1
System B are accessable from the back panel.
See "System Module (SMOD) Overview" on page

Remove an SMOD

Perform this procedure to access internal SMOD components, such as the HBA card, the
internal USB ports, the ESM, and the system battery.
Before You Begin
Note -
For component serviceability, locations, and designations, see
■
Components" on page
Obtain labels and a pen for labeling cables.
■
Prepare the server for cold service.
1.
SMODs should be removed and replaced only by authorized Oracle Service
Internal USB ports are not used.
24.
Servicing System Module (SMOD) Components (FRU)
34.
34.
"Identifying
Servicing Components 195