Attach Devices to the Server
Attach Devices to the Server
This section provides instructions for connecting remote and local devices to the server so you
can interact with the service processor (SP) and the server console.
For port and connector information, see
1.
Connect an Ethernet cable to the Gigabit Ethernet (NET) connectors as needed
for OS support.
2.
To connect to Oracle ILOM over the network, connect an Ethernet cable to the
Ethernet port labeled NET MGT.
3.
To access the Oracle ILOM command-line interface (CLI) locally using the
management port, connect a serial null modem cable to the RJ-45 serial port
labeled SER MGT.
Back Panel Connector Locations
The following illustration shows and describes the locations of the back panel connectors. Use
this information to set up the server, so that you can access diagnostic tools and manage the
server during service.
The following figure shows the locations of the server back panel connectors and ports.
90
Oracle Server X7-8 Service Manual • October 2017
"Back Panel Components" on page
21.