Bios Advanced Menu Iscsi Configuration Options - Oracle X7-8 Service Manual

"BIOS Advanced Menu Primary Video Selection Options" on page 281
■
"BIOS Advanced Menu Trusted Computing 2.0 Options" on page 281
■
"BIOS Advanced Menu Processor Configuration Options" on page 282
■
"BIOS Advanced Menu Memory Configuration Options" on page 283
■
"BIOS Advanced Menu CPU Power Management Configuration Options" on page 284
■
"BIOS Advanced Menu USB Ports Options" on page 285
■
"BIOS Advanced Menu Error Injection Settings Option" on page 285
■
"BIOS Advanced Menu Disk Freeze Lock Settings Option" on page 285
■
BIOS Advanced Menu iSCSI Configuration
Options
The following table describes the BIOS Advanced Menu iSCSI configuration options.
Setup Options
iSCSI Initiator Name
Add an Attempt
iSCSI Attempt Name
iSCSI Mode
Internet Protocol
Connection Retry Count
Connection Establishing
Timeout
Options
NA (must be specified)
NA (must be specified)
Disabled/Enabled/Enabled for
MPIO
IP4/IP6/Autoconfigure
0 to 16
NA
Defaults
None
None
Disabled
IP4
0
1,000
BIOS Setup Utility Menu Options
BIOS Advanced Menu Selections
Description
The worldwide unique name of
the iSCSI Initiator. Only IQN
format is accepted.
The human-readable name that
you assigned to this attempt.
Set to Enabled for multipath I/
O (MPIO). MPIO can boost the
performance of an application
by load-balancing traffic across
multiple ports.
Can be set to IP4, IP6, or
Autoconfigure. The initiator
IP address is assigned by the
system to IP6. In Autoconfigure
mode, the iSCSI driver attempts
to connect to the iSCSI target
using the IPv4 stack. If this fails,
then the iSCSI driver attempt to
connect using the IPv6 stack.
The count range is 0 to 16. If set
to 0, there are no retries.
The timeout value in
milliseconds. The minimum
value is 100 milliseconds and
the maximum is 20 seconds.
275