Oracle X7-8 Service Manual page 73

Front Panel Lamp Test
■
For the error state scenarios described below, the OK indicator state depends on presence
Note -
of redundant components and the severity of the fault.
Server Boot Process and Normal Operating State Indicators
A normal server boot process involves System A (SMOD0) or System B (SMOD1) service
processor SP OK indicator and System OK indicator. The following illustration shows callout 1
SMOD0 System A and callout 2 SMOD1 System B.
Call System Activity
Out
1 System A ■ Single 4 socket: The FIM provides controls and indicators for System A (SMOD0) only.
SMOD0
■ Dual 4 socket: The FIM provides separate controls and indicators for System A (SMOD0) and System B
■ 8 socket: The FIM provides controls and indicators for System A (SMOD0) and System B CMODs 4-7.
2 System B ■ Single 4 socket: System B (SMOD1) buttons and indicators are not operational.
SMOD1
■ Dual 4 socket: The FIM provides separate controls and indicators for System A (SMOD0) and System B
■ 8 socket: The FIM provides controls and indicators for System A (SMOD0) and System B CMODs 4-7.
The following table describes the indicator activity during a normal boot sequence.
System Condition
AC power applied to server. SP is booting.
SP is booted and ready to use. Host is off.
(SMOD1).
Other System B (SMOD1) buttons and indicators are not operational.
(SMOD1).
Other System B (SMOD1) buttons and indicators are not operational.
Troubleshooting Using Status Indicators
SP Indicator
Blinks
Steady On
Troubleshooting and Diagnostics
Power OK Indicator
Off
Blinks at single blink rate (quick
flash every 3 seconds)
73