Prepare The Server For Cold Service (Oracle Ilom Cli) - Oracle X7-8 Service Manual

Prepare the Server for Cold Service (Oracle ILOM CLI)

2. Power down the server. In the Actions section of the Summary Information page,
click the Power State Turn Off button.
This action powers off the server to Standby power mode. For more power off options, see
"Powering Down the Server" on page
In the Actions section of the Summary Information page, click the Locator
3.
Indicator Turn On button.
This action activates the Locate Button/LED indicator LED on the server front panel. For other
options, see
4. Click OK.
5. Once at the service location, press the Locate Button/LED button to deactivate
the indicator.
For more information, see
6. Set up an ESD-safe space at the service location.
Set up a space where you can set components. See
Static Prevention Measures" on page
7. Perform warm service removal and installation procedures on components.
See "Servicing Components" on page
Prepare the Server for Cold Service (Oracle ILOM
CLI)
This procedure describes how to prepare the server for cold service when you remove, replace,
or install cold-serviceable components. A cold-service component must be serviced when
the server is completely powered off and AC cords have been removed from the back panel
AC power block. For more information about component serviceability, see
Serviceability Requirements" on page
108 Oracle Server X7-8 Service Manual • October 2017
"Managing the Locate Button/LED" on page
"Control the Locate Button/LED Locally" on page
111.
120.
"Performing Electrostatic Discharge and
98.
123.
26.
121.
"Component