Clear Hardware Fault Messages (Oracle Ilom) - Oracle X7-8 Service Manual

After servicing the component, you might need to clear the fault in Oracle ILOM. Refer
Note -
the service procedure for the component for more information.

Clear Hardware Fault Messages (Oracle ILOM)

After servicing the following components, you must clear the fault event in Oracle ILOM:
Processor (CPU)
■
PCIe card
■
HBA
■
Front Indicator Module (FIM)
■
This procedure uses the Oracle ILOM CLI interface. Use the Oracle ILOM CLI to access the
Fault Management Shell, fmadm.
For more information about how to use the Oracle ILOM Fault Management Shell and
supported commands, see the Oracle ILOM User's Guide for System Monitoring and
Diagnostics Firmware: Release 4.0.x in the Oracle Integrated Lights Out Manager (ILOM) 4.0
Documentation Library at http://www.oracle.com/goto/ilom/docs.
The purpose of the Oracle ILOM Fault Management Shell is to help Oracle Service
Caution -
personnel diagnose system problems. Customers should not launch this shell or run fault
management commands in the shell unless requested to do so by Oracle Service personnel.
Open an SSH session and at the command line log in to the SP Oracle ILOM CLI.
1.
Log in as a user with root or administrator privileges. For example:
ipaddress
ssh root@
where ipaddress is the IP address of the server SP.
For more information, see
The Oracle ILOM CLI prompt appears:
->
2.
To access fmadm, type:
start /SP/faultmgmt/shell
The fmadm prompt appears:
"Using Oracle ILOM" in Oracle Server X7-8 Installation
Clear Hardware Fault Messages (Oracle ILOM)
Troubleshooting and Diagnostics
Guide.
53