Prepare The Server For Hot Service (Oracle Ilom Cli) - Oracle X7-8 Service Manual

Fan frame "Servicing Fan Modules (CRU) and Fan Frames (CRU)" on page 129
■
Front indicator module (FIM)
■
(FRU)" on page 218
Midplane "Replace the Midplane Assembly" on page 226
■
Internal USB flash drive (not used)
■
See "Prepare the Server for Cold Service (Oracle ILOM CLI)" on page 108
Server for Cold Service (Oracle ILOM Web Interface)" on page
The steps in these remote procedures use the Oracle ILOM CLI interface or web interface. For
more information, refer to the Oracle ILOM 4.0 documentation.
"Accessing Oracle ILOM" in Oracle Server X7-8 Installation Guide
■
"Using Oracle ILOM" in Oracle Server X7-8 Installation Guide
■
Oracle Integrated Lights Out Manager Documentation Library at:
■
http://www.oracle.com/goto/ilom/docs
For additional detailed information, see:
"Managing the Locate Button/LED" on page 120
■
"Servicing Components" on page 123
■
Prepare the Server for Hot Service (Oracle ILOM
CLI)
This procedure describes how to prepare the server to remove, replace, or install hot-service
components. A hot-service component can be serviced while the server is operating at
Main power mode. For more information about component serviceability, see
Serviceability Requirements" on page
Open an SSH session and at the command line log in to the SP Oracle ILOM CLI.
1.
Log in as a user with root or administrator privileges. For example:
ipaddress
ssh root@
where ipaddress is the IP address of the server module SP. Type a password when prompted.
For more information, see
The Oracle ILOM CLI prompt appears: ->

Prepare the Server for Hot Service (Oracle ILOM CLI)

"Servicing the Front Indicator Module
26.
"Using Oracle ILOM" in Oracle Server X7-8 Installation
or "Prepare the
110.
"Component
Guide.
Preparing for Service 103