The connector on the ESM is at the end of a cable that dangles about four inches out of the
ESM body.
13.
Inspect the cable to make sure that it is routed correctly and connected to the
ESM and the HBA.
14.
Install the SMOD. See
15.
Prepare the server for operation. See
Operation" on page
Servicing the SAS Cable
This section contains information about the Mini-SAS4I cables:
"Replace the SAS Cable" on page 212
■
For component serviceability, locations, and designations, see
Components" on page
"Install an SMOD" on page
"Returning the Server to
237.
24.
Replace the ESM Extension Cable
197.
"Identifying
Servicing Components
211