Prepare The Server For Hot Service (Oracle Ilom Web Interface) - Oracle X7-8 Service Manual

Prepare the Server for Hot Service (Oracle ILOM Web Interface)

2. Verify that the Power State is OFF:
At the prompt, type the following command:
stop /System
To turn on the Locate Button/LED, type the following command:
3.
set /System/ locator_indicator=on
Note -
4. Once at the service location, press the Locate Button/LED button to deactivate
the indicator.
For more information, see
5. Set up an ESD-safe space at the service location.
Set up a space where you can set components. See
Static Prevention Measures" on page
6. Perform hot service removal and installation procedures on components.
See "Servicing Components" on page
Prepare the Server for Hot Service (Oracle ILOM
Web Interface)
This procedure describes how to prepare the server to remove, replace, or install hot-service
components. A hot-service component can be serviced while the server is operating at
Main power mode. For more information about component serviceability, see
Serviceability Requirements" on page
1. Log in to the service processor Oracle ILOM web interface.
Direct a web browser to Oracle ILOM using the IP address of the server SP and log in as root
or a as user with administrator privileges. See
Installation
The Summary Information page appears.
2. In the Actions section of the Summary Information page, click the Locator
Indicator Turn On button.
104 Oracle Server X7-8 Service Manual • October 2017
To turn off the Locator indicator, type:
"Control the Locate Button/LED Locally" on page
Guide.
set /System/ locator_indicator=off
"Performing Electrostatic Discharge and
98.
123.
26.
"Accessing Oracle ILOM" in Oracle Server X7-8
.
121.
"Component