Zoneset Activate - HP 5920 Series Command Reference Manual

Parameters
old-name: Specifies the name of the zone alias to be renamed, a case-sensitive string of 1 to 64
characters. This name can contain letters (uppercase and lowercase), numbers, and special characters
(see Table 29). It must start with a letter.
new-name: Specifies the new zone alias name, a case-sensitive string of 1 to 64 characters. This name
can contain letters (uppercase and lowercase), numbers, and special characters (see
start with a letter.
Examples
# Create a zone alias named za1.
<Sysname> system-view
[Sysname] vsan 1
[Sysname-vsan1] zone-alias name za1
[Sysname-vsan1-zone-alias-za1] quit
# Rename zone alias za1 as za2.
[Sysname-vsan1] zone-alias rename za1 za2
Related commands
• display zone-alias
zone-alias name
•

zoneset activate

Use zoneset activate to activate a zone set as the active zone set and distribute it to the entire fabric.
Use undo zoneset activate to delete the active zone set and distribute the deletion to the entire fabric.
Syntax
zoneset activate name zoneset-name
undo zoneset activate
Views
VSAN view
Predefined user roles
network-admin
Parameters
name zoneset-name: Specifies the zone set to be activated by its name, a case-sensitive string of 1 to 64
characters. This name can contain letters (uppercase and lowercase), numbers, and special characters
(see Table 29). It must start with a letter.
Usage guidelines
Each VSAN can have multiple zone sets. However, only one zone set can be effective at a time. It is
called the active zone set. The active zone set must contain at least one N_Port member and determines
access control over N_Ports.
In basic zoning mode, if the size of the zone set to be activated exceeds the system limit, the activation
fails. In either basic or enhanced zoning mode, the system prints a log message if the activation fails. To
ensure a consistent active zone set across the fabric, reactivate the zone set.
121
Table 29). It must