HP 5920 Series Command Reference Manual page 29

Field
FC mode
state
Support the VSAN protocol
VSAN tagging mode
EVFP common VSAN
Bound interface
Bound MAC
VSAN of physical-UP state
Last clearing of counters
# Display brief information about interface VFC 1.
<Sysname> display interface vfc 1 brief
Brief information on VFC interface(s):
Admin Mode: auto - auto; E - e port; F - f port; NP - n port proxy
Oper Mode: E - e port; F - f port; NP - n port proxy;
TE - trunking e port; TF - trunking f port;
TNP - trunking n port proxy
Interface Admin Admin Oper Status Bind
Mode Trunk Mode
Mode
Vfc1 F on
Table 5 Command output
Field
Interface
Admin Mode
Admin Trunk Mode
Description
Mode of the VFC interface.
Operating mode of the VFC interface through negotiation.
Indicates the VFC interface supports the VSAN protocol.
Link type of the interface: Trunk (Tagging) or Access (Non
tagging).
VFC interfaces support only Tagging.
Indicates that the common VSANs are in up state through the
EVFP negotiation.
This field is displayed only after the link goes up.
Physical interface bound to the VFC interface.
FCoE MAC address bound to the VFC interface.
List of VSANs that are physically up.
Time when the interface statistics were last cleared by using the
reset counters interface command. Never indicates that the
interface statistics have never been cleared since switch startup.
Interface
TF UP XGE1/0/1 0102-0304-0506
Description
Name of the VFC interface.
User-configured VFC interface mode:
•
E.
•
F.
•
NP.
User-configured trunk mode for the VFC interface: on.
23