Fcs Commands; Fcs Discovery Start - HP 5920 Series Command Reference Manual

Use undo fip-snooping port-mode to restore the default.
Syntax
fip-snooping port-mode { enode | fcf }
undo fip-snooping port-mode
Default
An Ethernet interface operates in ENode mode.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
enode: Specifies the ENode mode.
fcf: Specifies the FCF mode.
Usage guidelines
Ethernet interfaces on a Transit switch can operate in ENode mode or FCF mode. An Ethernet interface
connected to an ENode must be configured to operate in ENode mode. An Ethernet interface connected
to an FCF switch must be configured to operate in FCF mode.
Examples
# Configure interface Ten-GigabitEthernet 1/0/2 to operate in FCF mode.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/2
[Sysname-Ten-GigabitEthernet1/0/2] fip-snooping port-mode fcf

FCS commands

fcs discovery start

Use fcs discovery start to start a topology discovery.
Syntax
fcs discovery start [ age interval ] vsan vsan-list
Views
System view
Predefined user roles
network-admin
Parameters
age interval: Specifies the aging time for the topology discovery information, in the range of 300 to
86400 seconds. The default is 900 seconds.
vsan vsan-list: Specifies a list of VSANs in which a topology discovery is started. The vsan-list is indicated
in the form of vsan-list = vsan-id [ to vsan-id ], where vsan-id is in the range of 1 to 3839.
138