HP 5920 Series Command Reference Manual page 13

Field
Fill word
FC mode
state
Transmit B2B Credit
Receive B2B Credit
Support VSAN Protocol
VSAN tagging mode
EVFP common VSAN
Link speed type is autonegotiation
Link speed type is force link
Flow-control
The Maximum Frame Length
Last clearing of counters
Peak value of input
Peak value of output
Last 300 seconds input: 0
packets/sec 9 bytes/sec 0%
Last 300 seconds output: 0
packets/sec 9 bytes/sec 0%
Description
Fill word mode of the FC interface:
•
idle-idle.
•
idle-arbff.
Mode of the FC interface.
Operating mode of the FC interface through negotiation.
BB_Credit value of the local end.
This field is displayed only after the link comes up.
BB_Credit value of the remote end. This field is displayed only after the
link comes up.
The FC interface supports the VSAN protocol after negotiation.
This field is displayed only after the link comes up.
VSAN tagging mode of the FC interface after the Exchange Virtual
Fabrics Protocol (EVFP) negotiation: Tagging or Non tagging.
This field is displayed only after the link comes up.
Common VSANs in up state through the EVFP negotiation.
This field is displayed only after the link comes up.
This field is displayed if the speed auto command is configured.
This field is displayed if a specific rate is configured by using the speed
command.
Flow control function status of the FC interface:
•
enabled.
•
not enabled.
Maximum allowed frame size on the FC interface.
Time when the interface statistics were last cleared by using the reset
counters interface command. Never indicates that the interface statistics
have never been cleared since switch startup.
Peak incoming traffic rate on the FC interface.
Peak outgoing traffic rate on the FC interface.
Average incoming traffic rate on the FC interface in the last 300 seconds
and the percentage of the actual rate to the maximum interface rate
(configured by using the speed command).
A hyphen (-) indicates that the statistics item is not supported.
Average outgoing traffic rate on the FC interface in the last 300 seconds
and the percentage of the actual rate to the maximum interface rate
(configured by using the speed command).
A hyphen (-) indicates that a statistics item is not supported.
7