Default; Description - HP 5920 Series Command Reference Manual

Parameters
bandwidth-value: Specifies the expected bandwidth in the range of 1 to 400000000 kbps.
Usage guidelines
The baud rate of an FC aggregate interface is the sum of the speed of each Selected member interface
in the FC aggregation group.
The expected bandwidth of an FC aggregate interface affects the link costs in FSPF. You can control the
route selection by configuring the expected bandwidth.
Examples
# Set the expected bandwidth of FC aggregate interface 3 to 1000 kbps.
<Sysname> system-view
[Sysname] interface san-aggregation 3
[Sysname-SAN-Aggregation3] bandwidth 1000

default

Use default to restore the default settings for an FC aggregate interface.
Syntax
default
Views
FC aggregate interface view
Predefined user roles
network-admin
Usage guidelines
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of the
impacts of this command when you execute it on a live network.
This command might fail to restore the default settings for some commands for reasons such as command
dependencies and system restrictions. Use the display this command in interface view to identify these
commands. Then use their undo forms or follow the command reference to restore their default settings.
If your restoration attempt still fails, follow the error message instructions to resolve the problem.
Examples
# Restore the default settings for FC aggregate interface 3.
<Sysname> system-view
[Sysname] interface san-aggregation 3
[Sysname-SAN-Aggregation3] default
This command will restore the default settings. Continue? [Y/N]:y

description

Use description to configure a description for an FC aggregate interface.
Use undo description to restore the default.
28