Fip Snooping Commands; Display Fip-Snooping Enode - HP 5920 Series Command Reference Manual

external-interface interface-type interface-number: Specifies an uplink interface by its type and number,
which can be an FC or VFC interface.
Usage guidelines
This command is available only on switches operating in NPV mode.
A downlink interface selects an uplink interface to map as follows:
When uplink-to-downlink interface mappings are configured for the downlink interface, the
•
downlink interface can select an uplink interface from only the configured mappings.
When no uplink-to-downlink interface mapping is configured for the downlink interface, the
•
downlink interface can select an uplink interface from all uplink interfaces in the same VSAN.
Examples
# Configure a mapping between FC 1/0/1 (downlink interface) and FC 1/0/2 (uplink interface).
<Sysname> system-view
[Sysname] vsan 10
[Sysname-vsan10] npv traffic-map server-interface fc 1/0/1 external-interface fc 1/0/2

FIP snooping commands

display fip-snooping enode

Use display fip-snooping enode to display ENode information obtained by the Transit switch.
Syntax
display fip-snooping enode [ vlan vlan-id ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
vlan vlan-id: Specifies a VLAN by its ID in the range of 1 to 4094. If you do not specify a VLAN, this
command displays ENode information for all VLANs.
Examples
# Display ENode information obtained by the Transit switch.
<Sysname> display fip-snooping enode
VLAN 2:
Interface
XGE1/0/1
Table 40 Command output
Field
Interface
ENode MAC
ENode WWN
21:01:00:1b:32:a0:fa:18
Description
Ethernet interface connecting the Transit switch to the ENode.
FCoE MAC address of the ENode.
ENode MAC
000c-2999-eacd
132