Zoneset Clone - HP 5920 Series Command Reference Manual

In basic zoning mode, the distribution type specified by using the zoneset distribute full command
applies to distribution operations triggered by the zoneset activate command.
Examples
# Create a zone named z1.
<Sysname> system-view
[Sysname] vsan 1
[Sysname-vsan1] zone name z1
# Add an N_Port with the FC address as 010000 to zone z1.
[Sysname-vsan1-zone-z1] member fcid 010000
[Sysname-vsan1-zone-z1] quit
# Create a zone set named zs1.
[Sysname-vsan1] zoneset name zs1
# Add zone z1 to zone set zs1.
[Sysname-vsan1-zoneset-zs1] member z1
[Sysname-vsan1-zoneset-zs1] quit
# Activate zone set zs1 and distribute it to the entire fabric.
[Sysname-vsan1] zoneset activate name zs1
Related commands
• display zoneset active
zoneset distribute full
•

zoneset clone

Use zoneset clone to create a zone set by copying an existing zone set.
Syntax
zoneset clone src-name dest-name
Views
VSAN view
Predefined user roles
network-admin
Parameters
src-name: Specifies the name of the source zone set to be copied, a case-sensitive string of 1 to 64
characters. A source zone set name can contain letters (uppercase and lowercase), numbers, and
special characters (see
dest-name: Specifies the name of the destination zone set, a case-sensitive string of 1 to 64 characters.
A destination zone set name can contain letters (uppercase and lowercase), numbers, and special
characters (see
Examples
# Create a zone set named zs1.
<Sysname> system-view
[Sysname] vsan 1
[Sysname-vsan1] zoneset name zs1
Table 29). It must start with a letter.
Table 29). It must start with a letter.
122