Views
FC interface view, FC aggregate interface view
Predefined user roles
network-admin
Parameters
vsan-id: Specifies a VSAN by its ID in the range of 1 to 3839. Make sure the VSAN already exists on the
switch. Otherwise, this command fails.
Usage guidelines
To assign multiple interfaces to a VSAN as access ports in batch, use the port command.
Examples
# Assign interface FC 1/0/1 to VSAN 10 as an access port.
<Sysname> system-view
[Sysname] vsan 10
[Sysname-vsan10] quit
[Sysname] interface fc 1/0/1
[Sysname-Fc1/0/1] port access vsan 10
Related commands
port
port trunk mode
Use port trunk mode to configure the trunk mode of an interface.
Use undo port trunk mode to restore the default.
Syntax
port trunk mode { auto | off | on }
undo port trunk mode
Default
On an FCF switch, the trunk mode of an interface is auto.
On an NPV switch, the trunk mode of an interface is off.
Views
FC interface view, FC aggregate interface view
Predefined user roles
network-admin
Parameters
auto: Specifies the auto mode.
off: Specifies the off mode.
on: Specifies the on mode.
Usage guidelines
The trunk mode of an interface can be auto, on, or off.
47