Priority - HP 5920 Series Command Reference Manual

Default
No default FC4 information is configured.
Views
System view
Predefined user roles
network-admin
Parameters
wwn-value: Specifies an N_Port by its WWN in the format of xx:xx:xx:xx:xx:xx:xx:xx (hexadecimal).
type-value: Specifies a supported FC4-Type by its value in the range of 0 to 255. The FC4-Type field is
256 bits, each of which represents an FC4-Type. If a bit is set to 1, the FC4-Type that the bit represents
is supported. Only one bit can be set to 1 at the same time.
scsi-fcp: Specifies the supported FC4-Type as SCSI-FCP, which has a type-value of 8.
feature feature-map: Specifies the Feature value for the supported FC4-Type. The value range for
feature-map is 0 to 15. The Feature field is 4 bits, each of which represents a Feature. If a bit is set to 1,
the Feature that the bit represents is supported. Multiple bits can be set to 1 at the same time. For example,
if the value is set to 15, the node supports four Features of the FC4-Type. If the value is set to 0, the node
supports none of the four Features. When you specify supported FC4-Type as SCSI-FCP, you can
configure the following keywords:
initiator: Specifies support for the initiator Feature, which has a feature-map of 2.
•
• target: Specifies support for the target Feature, which has a feature-map of 1.
both: Specifies support for both initiator and target Features, which has a feature-map of 3.
•
Usage guidelines
The switch records the default FC4 information in the name service database for a node when the
following conditions exist:
• The node does not register FC4 information.
The switch fails to obtain SCSI-FCP information from the node.
•
The switch replaces the default FC4 information with the registered FC4 information or obtained
SCSI-FCP information when one of the following events occurs:
A node registers FC4 information.
•
The switch obtains the SCSI-FCP information.
•
This command can configure only one combination of FC4-Type and Feature at a time.
Examples
# Configure the default FC4 information for the node with WWN 00:00:00:1 1:22:33:44:55.
<Sysname> system-view
[Sysname] fc wwn 00:00:00:11:22:33:44:55 default-fc4-type scsi-fcp feature target
[Sysname] fc wwn 00:00:00:11:22:33:44:55 default-fc4-type 9 feature 7

priority

Use priority to configure the switch priority in a VSAN.
Use undo priority to restore the default.
68