Table of Contents
Advertisement
Modify alerts
Use the following steps to modify an existing threshold alert configuration:
1.
At the Hardware View page, select Configure > Threshold Alerts. The Configure Threshold Alerts
dialog box is displayed.
Select the alert that you want to modify by clicking the alert information in the table. If the alert
is active, an error message is displayed prompting you to deactivate the alert.
2.
If the alert is active, click Deactivate, then select the alert information in the table again.
3.
Click Modify. An initial Modify Threshold screen that allows the you to change the threshold type
is displayed.
4.
Select a threshold type from the drop-down list.
5.
Click Next when you are done. A Modify Threshold screen is displayed. This screen allows you
to change the % utilization, cumulative minutes for the threshold to occur before notification, and
the time interval for measuring throughput and for alert notification.
6.
Make appropriate changes, then continue through the Modify Threshold screens, making
changes as necessary, until the summary screen is displayed in the alert configuration.
7.
Perform either of the following steps:
• If you need to change any parameters, click Previous or Next to display the desired Modify
Threshold screen.
• Click Finish when you are done.
Activate or deactivate alerts
Use the following steps to activate or deactivate existing threshold alerts. In the active state,
notifications are generated for the alert. In the inactive state, notifications do not occur.
1.
At the Hardware View page, select Configure > Threshold Alerts. The Configure Threshold Alerts
dialog box is displayed.
The port's current state, inactive or active, is listed in the State column.
2.
To change the state, select the alert by the alert information in the table.
3.
If the alert is active, select Deactivate to change to the inactive state. If the alert is inactive, select
Activate to change to the active state.
Delete alerts
Use the following steps to delete existing threshold alerts:
1.
At the Hardware View page, select Configure > Threshold Alerts. The Configure Threshold Alerts
dialog box is displayed.
2.
Select the alert that you want to delete by selecting the alert information in the table and click
Delete. A message is displayed asking you to confirm the deletion.
3.
Click Yes. The alert is removed from the dialog box.
62
Installing and configuring the Edge Switch 2/32
Advertisement
Table of Contents
