HP 5920 Series Command Reference Manual page 12

EVFP common VSAN : 1
Media type is optical fiber,Port hardware type is 16G_FC_SW_SFP
Port priority: 0
4Gbps-speed mode, Link speed type is autonegotiation, Flow-control is enabled
The Maximum Frame Length is 10000
Last clearing of counters: Never
Peak value of input: 32 bytes/sec, at 2014-12-12 12:26:02
Peak value of output: 32 bytes/sec, at 2014-12-12 12:25:41
Last 300 seconds input:
Last 300 seconds output:
Input (total): 142 packets, 13596 bytes
142 unicasts, 0 broadcasts,
Input (normal): 142 packets, - bytes
142 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Input: 0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
Output (total): 139 packets, 13748 bytes
139 unicasts, 0 broadcasts,
Output (normal): 139 packets, - bytes
139 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Output: 0 output errors,
0 aborts,
0 lost carrier, - no carrier
Table 1 Command output
Field
Current state
Line protocol state
Description
Bandwidth
Maximum Transmit Unit
4000Mbps-speed mode
Internet protocol processing
Link layer protocol
0 packets/sec 9 bytes/sec 0%
0 packets/sec 9 bytes/sec 0%
0 multicasts, 0 pauses
0 multicasts, 0 pauses
- underruns, - buffer failures
0 deferred, 0 collisions, 0 late collisions
Description
Physical state and administrative state of the FC interface:
•
Administratively Down—The interface is administratively shut down by
using the shutdown command.
•
DOWN—The interface is administratively up but physically down.
•
DOWN (NPV uplink port not available)—The interface is
administratively up but physically down, because its uplink interface is
down or no uplink interface is created.
•
DOWN (SAN Aggregation interface down)—The interface is
administratively up but physically down, because its FC aggregate
interface is down.
•
UP—The interface is up both administratively and physically.
Link layer protocol state of the FC interface: DOWN or UP.
Description of the FC interface.
Expected bandwidth of the FC interface.
MTU of the FC interface.
Rate of the FC interface.
IP packet processing capability. If the FC interface is not configured with
an IP address, this field displays disabled.
Link layer protocol of the FC interface.
6