Snmp-Agent Trap Enable Fc-Zone - HP 5920 Series Command Reference Manual

Predefined user roles
network-admin
Parameters
vsan vsan-id: Specifies a VSAN by its ID in the range of 1 to 3839. If you do not specify a VSAN, this
command clears zone packet statistics for zones in all VSANs.
Examples
# Clear zone packet statistics for VSAN 2.
<Sysname>reset zone statistics vsan 2
Related commands
display zone statistics

snmp-agent trap enable fc-zone

Use snmp-agent trap enable fc-zone to enable SNMP notifications for the zone module.
Use undo snmp-agent trap enable fc-zone to disable SNMP notifications for the zone module.
Syntax
snmp-agent trap enable fc-zone [ activation-completed | defaultzone-change | hardzone-change |
merge-failed | merge-succeeded ] *
undo snmp-agent trap enable fc-zone [ activation-completed | defaultzone-change | hardzone-change
| merge-failed | merge-succeeded ] *
Default
All SNMP notifications for the zone module are disabled.
Views
System view
Predefined user roles
network-admin
Parameters
activation-completed: Enables SNMP notifications for zone set activation or deactivation.
defaultzone-change: Enables SNMP notifications for default zone policy changes.
hardzone-change: Enables SNMP notifications for hard zoning status changes.
merge-failed: Enables SNMP notifications for merge failures.
merge-succeeded: Enables SNMP notifications for merge successes.
Usage guidelines
If you do not specify any keywords, this command enables all SNMP notifications for the zone module.
After you enable SNMP notifications for the zone module, the switch generates notifications for important
events of the zone module and sends the notifications to the SNMP module. For more information about
SNMP notifications, see Network Management and Monitoring Configuration Guide.
Examples
# Enable SNMP notifications for default zone policy changes.
113